Replace NPFA with IEC as shown below (marked in RED), then save and close.Open WD.ENV (in notepad) which is in the AeData folder (along with the Proj and Tutorial folders). ![]() Are they IEC or NFPA (I guess they are NFPA)? Click + of the Schematic Libraries to find out the default symbol libraries.In the Project Settings tab click Schematic Libraries then click Default. Check your project properties: right click project> properties. ![]() ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |